first layer 3d print nightmare - help!
imgur.com
Discover topics like 3d printing, and the magic of the internet at Imgur, a community powered entertainment destination. Lift your spirits with funny jokes, trending memes, entertaining gifs, inspiring stories, viral videos, and so much more from users like MentalUproar.

I’ve never been able to get a clean first layer with this machine. I have given it a beacon probe and it just made it much faster to get the same problem to happen again. Where am I going wrong?

  • muusemuuse@lemm.eeOPEnglish
    2·
    3 months ago

    I noticed something while printing. it doesnt have a bed mesh loaded when it prints. it saves the last mesh, but doesnt load it. why?

    • Reffu42@fedia.io
      0·
      3 months ago

      I think that was a change made a few years ago by the klipper devs. You’ll need to load the bed mesh explicitly in your print start macro before printing

      • muusemuuse@lemm.eeOPEnglish
        1·
        3 months ago

        should I have it remesh each time, save, then load the mesh at the start of each print or should I just have it recall a saved mesh?