Just your typical internet guy with questionable humor

  • 1 Post
  • 10 Comments
Joined 2 years ago
cake
Cake day: June 22nd, 2023

help-circle



  • With a 2 part mold, you do some holes for the water on what will be the back side of your tile and you should be good.

    I made 3 part because I need some details on what will be the top of the piece, little seams to show the separation of each hex, as well as the thinner walls on the bottom. I did try 2 part molds before, but getting it off the mold was near impossible most of the time. Like this, I can just push the piece off. Currently, only the presser has holes for the water, should I add it to the bottom piece, too?

    The thick walls are to endure the pressure and reduce warping, though maybe they could be thinner? I tested adding some gypsum to the mixture, waiting for one piece to dry further and already figured that I have to remove from the mold before it hardens too much, otherwise it’ll end up stuck (that or I have to properly sand/fill the pieces like bluewing said above)