You must log in or register to comment.
From the picture it seems that you need to change your fep sheet. When you look at the fep does the lines coincide with the marks it has?
My troubleshooting steps so far have been:
• Make sure temp is 26°
• Mix resin
• Make sure settings arecorrect
• Fep Was changed
• Plate was leveled.
Are the lines on the side of the print or on the top? Do they appear always on the same spots?
Try printing small callibration pieces, to see if it always happens
https://www.thingiverse.com/thing:4707289 https://www.tableflipfoundry.com/3d-printing/the-cones-of-calibration-v3/
I did. Im pretty sure it was a dead pixel causing it. I’ve replaced the screen and I’m testing now.
Tried changing it out. Still happening.
